Train-O-Matic - 02070328 - Shine LED light bar cold white including capacitors
Train-O-Matic Shine-Leisten
Features
8 yellow LEDs
Can be shortened in 4 steps from 120 mm to a minimum of 60 mm.
Also available in other light colors.
Including backup capacitors 2x 220uF / 25 V
Unabridged dimensions: 120 mm x 5.5 mm x 1.5 mm
Maximum current consumption at 16v: 30 mA
Power supply: 6-24 V (DC) / 4-16 V (AC)
8 yellow LEDs
Can be shortened in 4 steps from 120 mm to a minimum of 60 mm.
Also available in other light colors.
Including backup capacitors 2x 220uF / 25 V
Unabridged dimensions: 120 mm x 5.5 mm x 1.5 mm
Maximum current consumption at 16v: 30 mA
Power supply: 6-24 V (DC) / 4-16 V (AC)
ATTENTION! The light bar does not come with any printed instructions. Please inform yourself here on the product page.
Solder the capacitors
You can solder the supplied capacitors or those of other manufacturers to the marked points. Please note that the positive pole of the capacitors is usually provided with the long wire. Please find out from third-party manufacturers in advance to avoid polarity reversal.
You can solder the supplied capacitors or those of other manufacturers to the marked points. Please note that the positive pole of the capacitors is usually provided with the long wire. Please find out from third-party manufacturers in advance to avoid polarity reversal.
Shorten the light strips
You can shorten the light strips in 4 places. Make sure that the bridge is on the right side and always shorten the strips to the left of the soldering points.
You can shorten the light strips in 4 places. Make sure that the bridge is on the right side and always shorten the strips to the left of the soldering points.
Connect light strips
Make sure the bridge peer is on the right. Solder the power supply to the lower and middle solder point of the bar. The feed point can be freely set on the bar as long as only the middle and lower solder pads are connected.
Make sure the bridge peer is on the right. Solder the power supply to the lower and middle solder point of the bar. The feed point can be freely set on the bar as long as only the middle and lower solder pads are connected.
